Kod enforcera (nemogu sad da nadjem haos mi je u firmi), treba da imaš jednu kutijicu od bele providne plastike i na njoj žuti i crveni potenciometar, kojim se podešava osetljivost.
Našao... naravno ovo mora da je negde učvršćeno, a ne da visi kao svi alarmi negde ispod komandne table...
Setting the pre-intrusion stage - Turn the red pot (secondary adjuster for trigger output) to minimum before adjusting the yellow pot. Now, lightly tap the vehicle. If pre-intrusion output is set correctly, the yellow LED flashes ON (the siren chirps), but the red LED should not. If the yellow LED does not come on, turn the yellow pot clockwise to increase sensitivity. To reduce sensitivity, turn the yellow pot counterclockwise.
Setting the trigger (2nd) stage - Hit the vehicle hard enough to trigger the alarm. At correct sensitivity, both yellow and red LEDs should come on. If not, adjust the red pot to either increase or decrease sensitivity.
Našao... naravno ovo mora da je negde učvršćeno, a ne da visi kao svi alarmi negde ispod komandne table...
Setting the pre-intrusion stage - Turn the red pot (secondary adjuster for trigger output) to minimum before adjusting the yellow pot. Now, lightly tap the vehicle. If pre-intrusion output is set correctly, the yellow LED flashes ON (the siren chirps), but the red LED should not. If the yellow LED does not come on, turn the yellow pot clockwise to increase sensitivity. To reduce sensitivity, turn the yellow pot counterclockwise.
Setting the trigger (2nd) stage - Hit the vehicle hard enough to trigger the alarm. At correct sensitivity, both yellow and red LEDs should come on. If not, adjust the red pot to either increase or decrease sensitivity.
Comment